How to Use a Cutting Torch Tip Chart - Harris Products Group
The Harris Cutting Tip Chart contains information on tip style/size selection, oxygen gas pressure settings (pre-heat flame and cutting stream), cutting oxygen gas orifice (center hole) sizing, fuel gas pressure settings, hose size recommendation, …
Welding Tip Chart. The welding tip chart shows the proper tip sizes and oxygen and acetylene pressures related to the thickness of material to be welded. The chart should serve as a handy guide to be re-ferred to often. If too large a tip is used and the flame softened, the tip heats up unnecessarily and is often accompanied by a popping noise ...
Cutting, Brazing, Heating and Welding Tips - Harris Products Group
Cutting, Brazing, Heating and Welding Tips. Harris tips are manufactured with the highest grade materials available. Every Harris tip is 100% flame tested at the factory to ensure a perfect flame for every application.
Cut Charts - American Torch Tip
American Torch Tip cut charts will help you find very specific specs of our different cut chart models and see which one fits your best needs.
Torches - Harris Products Group
The quality of a torch cut is determine by several factors: • Tip size for thickness of steel. • Preheat flame setting. • Cutting oxygen pressure. • Cutting speed. • Condition of tip. DOWNLOAD OUR GENERAL THEORY OF OXY-FUEL CUTTING.
Identifying the right welding and cutting torch tips - The Fabricator
2003年10月9日 · The tip of a welding or cutting torch is where the action is (see Figure 1). Welding tips usually produce positive pressure (higher than 1 pound per square inch [PSI]) and are used at equal pressures of acetylene and oxygen.
Harris Torch Tips: How To Use a Cutting Torch
2019年5月2日 · Before learning how to use a cutting torch, wear fire-resistant clothing with protective boots. Then, adjust the gas and acetylene before using the torch. This article will show you the best way to use a Harris torch in a safe manner. …
• Correct cutting oxygen pressure must be available at torch entry. • Oxygen preheat pressures are for three hose torches. • For two hose torches set same gas pressures for both high and low preheat.
Harris Cutting Tip Charts - Hornet Cutting Systems
Allows you to cut both plate and pipe with only one machine and one power unit saving time and money. Combines HornetHD and Roto series machine into one machine. Machine is available in 5.0′ (1.5 m) , 6.6′ (2.0 m), 8.2′ (2.5 m) and 10.0′ (3.0 m) effective cutting widths.
Manufactured to meet the most rigid requirements of the metal fabrication industry, PROSTARTM replacement tips are designed to fit the majority of the gas equipment manufacturers’ styles (Airco®, Harris®, Oxweld®, Purox®, Smith® and Victor®), for …